View Full Version : NX plate kit or Zex

03-31-2014, 09:09 PM
Wondering if anybody has any experience with one or the other.
I am looking for a 75 shot down the road and wanted to get some first hand knowledge.

03-31-2014, 10:45 PM
i like the nx plate i have one for a trickflow and it looks clean, works good, and easy to install plus they are located in tx so ground shipping takes like 1 day but why run a 500$ plate if ur only gonna spray a 75 shot im running the nx proton kit right now with single shark nozzle and it works great and the whole kit is like 360$ if i remember right

04-01-2014, 06:53 AM
I like NX stuff. Which car is it going on? Carb/efi? Intake? I had an NX shark nozzle and on their recommended 75 shot jet setting my old 347 setup picked up like 90 rwhp, on their 100 shot setting it showed like 115-120 at the wheels. So their ratings are rwhp. Just make sure fuel pressure and bottle pressure are right and you take out an appropriate amount of timing and you are golden.

others here have had luck with the Zex kits as well, but I've never used one, only NX stuff and Speedtech on my current motor.

If I were going for a big kit I'd be going to Steve Johnson at Induction Solutions.

04-01-2014, 09:40 AM
I just want a small shot for the strip and then increase it when I go with a Dart block in a couple of years.

04-01-2014, 03:48 PM
Nx perimeter plates are very good

Sent from my iPhone 5S

Just Chuck
04-01-2014, 04:21 PM
I love the Zex dry kits for their simplicity.

Just Chuck
04-01-2014, 04:26 PM