-
04-17-2018, 04:56 PM
#1551

One day the same people that doubt your dream will tell people how they met you!
-
04-24-2018, 07:02 PM
#1552
Bold color choice. I like it.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
05-01-2018, 08:35 AM
#1553
Thank you! It didn't turn out right (was supposed to be way more blue) but I'm still really happy with it. I've got a lot more done, just waiting on plug wires now before I try and fire it off.
My name is Collin and I have a problem.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
05-10-2018, 09:09 AM
#1554
Not much to update here, I'm not getting any spark at the coils, also found that I modded the MS for a VR sensor when I have a hall effect sensor. Fixed that last night. Need time to do more troubleshooting. Hard to figure shit out in 30 minute intervals each night.
My name is Collin and I have a problem.
-
05-10-2018, 09:43 AM
#1555
Probably just something super simple you are overlooking with everything going on. Once you find it, it will probably be a "smack my head" moment lol

One day the same people that doubt your dream will tell people how they met you!
-
05-16-2018, 09:18 AM
#1556
I ended up pulling my coil harness I made completely out of the car last night to go through it and make sure I didn't screw something up. Surprisingly, I didn't wire anything there wrong. So I plugged it back in and went through each of the 8 plugs with a volt meter... All 8 of the signal ground wires back to the computer had a rock solid 5 volts.... Uhhh wut?!
Turns out my 1990 mustang has a 1991+ engine harness in it.
I soldered the SG to the correct grey/red wire, but then ran out of time. I have a few more checks and test to run, but I can't think of anything else that could be wrong, short of having a set of fried coils.....
Famous last words, right?
My name is Collin and I have a problem.
-
05-17-2018, 08:33 AM
#1557
Got the grounding sorted and finished my plug wires last night. (OOOooooo, AAAAAhhhhhh)

Car didn't start though. I took a few data logs and sent them off to a buddy to see if he can help me figure it out. I KNOW I have spark and fuel, so either the crank trigger isn't working right, or the timing offset is way off.
My name is Collin and I have a problem.
-
05-17-2018, 10:13 AM
#1558
My name is Collin and I have a problem.
-
05-23-2018, 03:45 PM
#1559
After yet another round of testing, I have some kinks (self imposed, of course) to work out with the crank trigger. There was some ambiguity in the wiring directions and I zigged when I should have zagged. Right now, the signal is all over the place and the coils are firing accordingly. Should be a couple of quick snips and solders and ***hopefully*** the fukin thing will start finally. Unless I managed to FUBAR something else up in the process...
My name is Collin and I have a problem.
-
05-23-2018, 09:03 PM
#1560
I feel my fingers crossed for you!

One day the same people that doubt your dream will tell people how they met you!
Bookmarks